Winding device for extension cord/mains cable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wind up long extension cords without twisting them
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 658
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As I was tired of the mess I had with some long power cables for yard work I decided it was time to fix the problem. Commercial parts I found either to expensive or to simple to be useful.
You will need 2 of the shown part plus some 16mm diameter rod which can be aluminum tubing or wooden rods. I used two ~500mm and two ~150mm pieces but the lengths can be made as desired and what cable length should be rolled up.
The two small holes at the base accept the pins of a Schuko plug so it doesn't hang around when winding up the cable.
Even printing 0.3mm layers with 0.6mm width (0.4mm nozzle) made for a lengthy print time of 9:45 per side! The rods I glued in with CA glue.
As I used the cheapest PLA I could find the print quality is pretty poor but for the purpose cheap is better than nice...…
Because I could and not had to I made two versions. cable-spool.stl is a one piece design. cable-spool-3part-xxx.stl is a 3 part design. One needs one piece of body and two pieces of plate plus four 4mm flathead screws to assemble it. I also applied a bit of CA glue in between.
The 3 piece version has the advantage that it is less likely to break as the layers are in a better orientation.