Geekvape belt holder

This is another model from my Vapor's World collection.

This belt holder for Geekvape Aegis Legend 2 is a practical solution for hands-free convenience while keeping your vape device secure and close at hand.

Fits belts up to 40mm wide and 4mm thick.

There are two different options:

• The first one has a clip that hooks onto your belt, so you can easily slap it on and off without having to do the whole belt-removing dance. And if you're feeling extra saucy, you can even clip it onto your waistband, no belt required! 
• The second option is like a snug little hug for your belt, with a loop that keeps it secure and prevents it from doing any disappearing acts. Your vape mod will never want to leave your side!

You need approx. 30cm/12in of elastic cord with a diameter of 4mm, just like this one here.

Printing information

Layer height: 0.15mm
Infill: 10%
Support: see pictures

support: holder with clip

support: holder with loop

Don't stress about setting up the right support if you're using the 3mf files. 
And those color changes at 44.60mm and 45.50mm for the sleek center line are all sorted for you too!

Hey guys, just a heads up - this model has some seriously detailed parts, so I'm recommending a layer height of 0.15mm. And even though I usually love my 0.6mm nozzle, I decided to switch things up and go with a 0.4mm nozzle for this one.
And whenever I'm wearing the holder on my belt, other vapers always come up to me and ask where the heck they can get one too! Then it's a good feeling to show a perfectly printed piece.
However, if any of you try a larger layer height or nozzle and get some good results, drop a comment and let us know!

Assembly information

• Insert one end of the elastic cord from the top through one of the holes in the belt holder and then through one of the knot holders.
• Tie a knot at the end. Pull that knot tightly so it doesn't come undone.
• Cut off any excess cord sticking out behind the knot.
• Push the knot holder into the back of the belt holder.
• Take the other end of the cord, pass it over the mod, then around the front flap, and back over the mod through the second hole in the belt holder and finally through the second knot holder.
• Choose the length of the cord so that it is tight but can still be released over the front flap.
• Tie a knot at the end of this second end of the elastic cord and cut off any excess.
• Push the second knot holder into the back of the belt holder as well.

If you feel like it, you can jazz up the front of the belt holder with some colorful accents. Print out some hexagons and glue them into the cutouts.

I am looking forward to your Makes! :-)

If you like this model, feel free to check out my others here.