Cisco Network Switch Wall Mount Brackets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brackets to mount a Cisco SG 100-16 network switch on the wall.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 119
- Wydruki
- 0
- Wyświetlenia
- 909
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I wanted to mount a Cisco SG 100-16 on the wall so I after measuring the dimensions, designed the right hand bracket and mirrored it in Prusa Slicer on the x-axis. The hole tolerances are tight but worked and the model is not symmetrical from top to bottom so there is a correct orientation that aligns - if I did a second version I would fix that but it works for my use so it's good enough. I've uploaded the 3mf and step files in case someone wants to take it farther.
The switch case has 4x M4 holes. I used just 2 per side and some random wall anchors that I had on hand that had a 3.5mm diameter.
I printed in draft mode and used a honeycomb infill pattern.
Two brackets are needed but it was hard to get a good picture, so only one side is shown in the image.