HackerBox #0089 - Case for "WiSPY" wardriving kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for the "WiSPY" wardriving kit that came in HackerBox #0089
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 90
- Wydruki
- 1
- Wyświetlenia
- 720
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
HackerBox #0089 came with a fun Wardriving project built on a main circuit board with external antennas and a microscopic display board.
This should print nicely in whatever PLA you like. If everything works out, this should snap together snugly.
This case will fit the components almost perfectly, with no screws and no tabs to hold everything together.
The bottom half of the case contains a support rim for the circuit board and a well in which the pointy ends of the soldered leads can sit. There are two small openings, one for the SD card and the other for the power lead.
The board is a drop-in fit, make sure the card reader fits through the little slot.
Remove the antennas from the display board and mount them separately on the back of the lid. There is a hexagonal pocket inside the case to hold the inside nut, so you can use a small wrench to tighten a nut and lock washer on the outside on both sides.
The display fits in a set of carefully arranged bosses on the inside of the lid. Make sure the Dupont connectors are on the right side of the assembly when you are facing the front of the outside of the case lid. The little board with display should snap in place fairly snugly. If needed, use a little bit of hot glue to keep it in position.
There is a ¼" slot in the top to fit the GPS sensor. You can hold it in with sticky tape or a dollop of hot glue.
No need to worry about the circuit board flopping around--there are two little feet in the lid that press down on the square shield near the antenna connector on each of the two ESP32 modules, holding the circuit board firmly in place.
Once everything is together, press the top and bottom together firmly--if you have printed them accurately, they should snap together.
Put some felt or cork on the bottom to dress it up a little.
I have included the FreeCAD file if you wish to fiddle around a bit. See the spreadsheet for parameters that can be tweaked.