Gridfinity baseplates for Harbor Freight parts organizer (medium)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fitted baseplates for the Harbor Freight "20 Bin Medium Portable Parts Storage Case"
- Ocena
- 4,333 / 5
- Polubienia
- 178
- Pobrania
- 675
- Wydruki
- 4
- Wyświetlenia
- 5115
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These baseplates fit the Harbor Freight medium sized small-parts organizer (this one). I included two variants, the minimal baseplate and the skeletonized version with magnets. The magnet holes are sized for press-fit without needing glue.
I'm crediting this as a remix since I took the dimensions from the original, but then I recreated it in onshape. This allowed me create it as a single piece, add padding in a couple more places for a nice snug fit, fillet the corners, etc. I also removed some of the height from the skeletonized baseplate compared to the openscad version. I use the openscad baseplates on my desk where I want some extra weight to help hold them in place, but that is not needed here and we can save filament/time and gain a few more mm of height for storage bins.
Update: the skeletonized base now has the screw holes in the magnet holes. This saves a little bit of filament plus allows you to push the magnets back out if you make a mistake.
I also made baseplates for the “large” organizer: https://www.printables.com/model/469250-gridfinity-baseplates-for-harbor-freight-parts-org