Filament-Unroller-Storage-Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As for my printers, especially MK3S+ with MMU2s I frequently change the unroll setup. Mostly I mix them with the MMU.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 443
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As for my printers, especially MK3S+ with MMU2s I frequently change the unroll setup. Mostly I mix them with the MMU. As my unrollers are mostly same “make”, but different widths I cannot really stack them. When I set my Prusa MK3S+ for MMU usage up, I always use another setup. Therefore, it is really handy since I printed this rack, to put them in the appropriate order. I have (who does not?) different widths and sized of filament. Leftovers or 500g rolls, etc.
Printed in PLA on my MK3S+
I attached the rack with some 3M doubleface adhesive to the shelf, so the lightweight rack stays in place.