Eufy Pet Treat Deflector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Treat Deflector for the Eufy Pet Camera / Treat Dispenser.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
I recently purchased a Eufy Pet Camera / Treat Dispenser to feed the cats treats when we are away. I like it, but even on the lowest setting it shoots the treats so far. They fly across the room and it either scares the cats or hits them in the head with treats.
I made this attachment that helps deflect the treats and aim them down towards the floor. Works much better now and the treats stay within about a foot or so of the device. I just used command strips to stick it over the treat dispenser hole.
5/17/23 Update: I added version 2 of the deflector which is shorter. It is about half the length of the original. The original was a bit too long and was visible on the camera.
Print Settings
Quick and easy print. Uses less than 20g of filament and I printed it in under an hour.
Printer: AnkerMake M5
Filament: PLA+
Infill: 5%
Supports: No, orient it straight up and it won't need any supports.
Layer Height: 0.2mm