Double-Row Metric Drillbit Holders 1 - 13 mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Double row drillbit holder (wall or table) Front and top plate can be printed in two colours.
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 190
- Wydruki
- 0
- Wyświetlenia
- 793
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Most of us have more that one drillbit of the same size but have only a stand or holder that holds one drillbit of that size.
This one holds two drillbits of the same size. There is a holder for 1 - 8 mm and another for 8.5 - 13 mm with increments of .5 mm
The thin top and front plates can be printed with two colours which is easily to do in most Slicer programs. Using the plates gives a minimal loss of filament if the filament change settings in the slicer is set wrong.
Use some transparent silicone to stick the plates to the holders. (Clean, easy to manipulate and strong bonding) Use on the workbench or mount to the wall using screws.
Print with any filament. Use low infill. No support neccesary.
Note: These are holders for metric drillbits, however feel free to create top and frontplates for imperial bits and link to the holders here.