1 / 5
adapter for mk3s+/CR10_Crusa MKC+10
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to use the MK3S+ extruder for the CR10.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An adapter to use the MK3S+ extruder for the CR10.
The Crusa MKC+10 is born :P
I printed in ABS+(black) from esun and in ASA Prusament.
Directions:
- Two M3 nuts must be used on the back.
- The holes for the screws are marked in red (frontside).
The previous version can still be seen in the picture, but this doesn't change the screws. - Then proceed according to the Prusa instructions, only when using the original motor the connector should be turned left or right.
- Before the adapter is screwed to the extruder, I continued to work on the printer.
- I still have a P.I.N.D.A. Adapter built on BLTouch because I already had it before.
If you want I can upload it too. - Happy printing