Bambu Lab AMS Anti-Vibration Dampening Mount P1P
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses the Bambu Lab Anti-Vibration Feet to reduce noise transmitted through the AMS when mounted to a P1P.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 1699
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Bambu Lab P1P Anti-Vibration AMS Mounts
Previously I had my AMS beside my P1P but changed my setup to where I needed to mount it on top, I printed the original mount kit from the Bambu Lab site and soon realised the noise resonating through the plastic AMS box is really bad when mounted on top of the P1P.
This design utilises the 4 extra Anti-Vibration feet you get in the Bambu Lab kit.
Most likely only suitable for bare P1P printers without any casing, although feel free to remix to suit. I did try a design where the mounts actually clip under the frame but the print head and casing run to close to the frame for this to work properly.
Tested for a good few hours of printing without any issues or movement, just a huge amount quieter!
You will need to print:
4 x AMS_Vibration_Frame_Mount - orientation as shown, use Tree supports, standard 0.2mm profile is fine, I used PLA but I'd imagine any filament of your choice expect something like TPU.
2 x AMS_Vibration_Runner - orientation as shown, no supports required, standard 0.2mm profile is fine. Again PLA or similar will work.
To fit:
You'll need to place the anti vibration mounts into the AMS_Vibration_Runner and then slot into the AMS unit. Place the 4 mounts on the frame and align. Push the anti vibration feet, along with runners and AMS into the mounts.