PX80 pod addapetert for PT60/PT80s
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapetert for the Swag PX80 pod in to the PT60/PT80s
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 528
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
-------------------------
Warning!: This modification requires partially disassembling your device and fiscal change to it. Perform at your own risk.
-------------------------
This is an adapter to be able to use the pod from the Swag Px80 in the GEN PT60/PT80s, You are going to be able to keep using the original Xtank pods.
You are going to have to drill/cut two intakes into your vape. I did it on the front and back as it looks better in my opinion, but is going to work where ever. The top border is around 3.25 mm from the top corner and the bottom one is 5.5 mm. Its length of it is around 10 to 10.1 mm.
Once this is done I would advise taking out the 2 screws in the top of the vape and disassembling it, to clean all the metal dust/sharts from drilling and cutting.
And while you're on it, I trimmed 1 mm of the two stand-offs inside, so that the pod sits flat.
Proceed, glueing the magnets into the adapter ring. Be aver of the polarity, all in the same direction as so your Xtank pod will hold on to it and it is still possible to rotate the air intake with two fingers.
And finally, pop that sucker in and let it rip!
Material used:
- 8 magnets: round 3x1mm or rectangular 2.5x2.3x1mm.
- Dremel for the cuting and drilling.
- Glue.
If your printer is super accused drop the thickness of the adapter to 1 mm.