CoreXY Belts Calibration Slat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 20x20mm square slat, at 45 degrees, with a simple notch to know orientation. You can quickly print them to…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 716
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
A simple 20x20mm square slat, at 45 degrees, with a simple notch to know orientation.
You can quickly print them to check and fine-tune your belts at your CoreXY system.
In order to do that:
1- Set your X and Y steps/mm to theoretical values.
2- Print this thing and measure both sides. There is no problem if they are not 20mm but they must be equal.
3- If they are not equal then:
If A>B then tight the A or lose the B belt
If B>A then tight the B or lose the A belt
When they are equal then you are set to calibrate your steps/mm for accurate printing. I strongly recommend this thing:
https://www.thingiverse.com/thing:2484766
You can also print 4 of these slats, one each corner, to check if your printer has parallelism issues.
Print Settings
Printer:
forkLIFT MK1
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
20%
Filament:
3DOn ABSAtlantis Blue
Category: 3D Printing Tests