1 / 4
Shield boss for children shields / Schildbuckel - No supports!
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Little upgrade for your children's shield: make it 3D with this shield boss!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
Little upgrade for your children's shield: make it 3D with this shield boss!
- Back is supported so it does not break easily
- Supposed to be screwed onto a wooden shield with four screws (solid portion with pilot bore). Make sure to print with enought walls to get a beefy part here - Go see the STL preview
- Your slicer may tell you that there may be stability issues coming to the top. Just ignore it, the substructure gives you enought support. looks are not important because it's on the inside!
- I quickly added a drillguide - completely made in PRUSA SLICER from the full model. Use it to bore the holes at the right spot (quick 10 min print - much faster than fixing a not aligning screw at the cost of 2 Cents!)