Hot glue gun horizontal/vertical mount - Pegboard compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hot glue gun holder. Can be mounted vertically or horizontally, including on a pegboard.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 590
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Imported from https://www.thingiverse.com/thing:3457548
A hot glue gun holder. Can be mounted vertically or horizontally, including on a pegboard. Should hold most small to large glue guns; the inner diameter of the holder is 45mm, and the smallest arc opening is 25mm wide.
Supports should only be needed on the mount body and grip sliders.
For larger glue guns, I've included a mount where the arc opening runs the full length of the mount (mount_body_lrg). It specifically works with this type of glue gun.
I've also included a few add-ons: both large and small glue-stick holders and a cord wrapper. How you use these is up to you, you can skip the cord wrap and print out left and right glue-stick holders, have two cord wrappers for some reason, etc.
If you are mounting it horizontally (like under a table), depending on your glue gun, you should print out two grip sliders to secure the gun. Slide them in the mount slots so that they pinch below the barrel of the glue gun and glue them in place.
If you are mounting on a pegboard, print out the pegboard hooks and run them through the mount holes.
Don't forget to print a drip catcher matching your orientation, they fit in the slots at the end of the mount.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
10%
Category: Tool Holders & Boxes