Bambu Lab - Xiaomi Temperature and humidity sensor for AMS system and Printers - Works With Mobile App

Hello Everyone 

I designed a housing for Xiaomi temperature and humidity sensor which I use in my AMS System. The original version only comes in white. I didn't want it to be so visible after assembly because of the white color. Therefore, the designed housing allowed me to change the color to black. The Xiaomi sensor is a great alternative to monitoring temperature and humidity because it has bluetooth communication and costs only about 6 euros. Work with Mobile App. If you want to monitor the temperature and humidity through this sensor while away from home, you must have a Xiaomi - Aqara gateway or connect it directly to Home Assistant or Homebridge. My sensors are ported over Homebridge to Homekit.

When you complete the project, please share a photo and a comment. Thank you and have a nice day.


Feel free to download and print another version of the housing for the Xiaomi temperature and humidity sensor from the link below:
https://www.printables.com/pl/model/462005-xiaomi-temperature-and-humidity-sensor-stand

Update 24.04.2023 :

• I am sharing the second version of the housing for the Xiaomi sensor with the top hole. This version is designed to attach the Xiaomi sensor to the wall or other surface with the back side. In this mounting version, the rear measuring hole is blocked. One hole is needed for proper temperature and humidity readings, in this case it will be the top one.
• I share the model file for testing the correct size

IMPORTANT - READ:
I tested the project on PLA filaments from brands such as Polymaker, FormFutura, Bambu Lab, Fiberlogy, Spectrum and Eryone. Each time the size after printing was perfect for the Xiaomi sensor. If you decide to print the housing with a different material, pay attention to its shrinkage and the settings of your printer. You can always make it a little bigger and if it's too loose, just use a piece of paper to make side pads. Download a file for a size trial print.

Version 1

• Designed to be mounted with double-sided adhesive tape mounted on the top of the sensor. As pictured for AMS System.

Version 2

• Designed to be mounted with double-sided adhesive tape mounted on the back of the sensor
   

How to print ? :

• Material : Any (I tested with PLA)
• Layer Height : 0.2mm
• Infill : 20%
• Wall Loops : 2
• Top Shell Layers : 3
• Bottom Shell Layers : 3
• Support : No
• Brim : No