Fountain Pen Tray R2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new and improved fountain pen tray. Now featuring *apples patented* rounded corners.
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 155
- Wydruki
- 0
- Wyświetlenia
- 1288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- GNU General Public License v3.0
A new and improved fountain pen tray or any writing utensil tray. Now featuring *apples patented* rounded corners. The fountain pen tray revision 2!
I included a single print stl, and a multi part stl.
This was initially designed to fit within a drawer I got from amazon.
Some Recommendations:
- This is a long, flat print. Use a brim if necessary. Cura slicer also can offer an anti-warp tab plugin if you want to go that route.
- I tried to design the corners to be rounded to help with layer adhesion
- A little bit of support might be needed where there is a small bridge where the locking tabs insert. Organic supports in prusa slicer 2.6, or tree supports are recommended, and work beautifully.
Single Part STL
You will need a large print volume for this print, unless you intend to scale it down. I suggest any bed that has a larger than 325mm in at least one of the cardinal directions.
Multi Part STL
You will need to print:
- Left Half
- Right Half
- 2x Locking Tabs
You will also need:
- 4x m3x4x5 heatset inserts [heatsets from DFH here]
- 4x m3x6 screws
*the heatsets linked are the exact ones I designed this around