Toyota Avensis T22 Blind Plug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Untested Version 2.0 available now!
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 828
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
ATTENTION! Version 1.0 did not hold very well. One of the clips was deformed after some time. I think it could be because of the PLA, but I don't really know yet. I used another solution now.
BUUUUT: I made a small improvement and released version 2.0. I don't know if that's a better solution so I need some feedback from you. Yes, YOU.
I needed a new Blind Plug for a 2002 Toyota Avensis T22 because the old one is not perfectly flat and I wanted to mount a holder for the garage door opener on it. I just put the 2 parts together with double side adhesive tape because i think it's easier to print as 2 parts.
If you only want to use it as Blind Plug you can use the textured sheet for better looks.
I did NOT remix this but I want to credit because it was my inspiration
"Bracket for Eazymatic garage door opener" by "olidub"
https://www.thingiverse.com/thing:4539075
It is for the left side of the steering wheel. Directly between the switch for the Mirror adjustment and the switch for the headlight adjustment.
Print instructions
Printer: Prusa Mini
Filament: Recommend something more temperature resistant then PLA. (PETG, ABS, ASA?)
Layer Height: 0.2mm Quality Setting in PrusaSlicer
Infill: Doesn't really matter because it's more perimeter then infill.
Supports: No