Train cars remix - no metal rods, no magnets, fully compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original model uses metal rods for wheels' axis, and magnets. This remix does not, only printed parts.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 104
- Wydruki
- 2
- Wyświetlenia
- 559
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
2024-03-30 update : after seeing a lot of the cars' linkages break, it was obvious the system was far too fragile especially for young kids. So I have made a V2 release of the car bodies (locomotive and car). It uses a simpler and stronger hooking system.
Note : the images hereunder are from the V1 of the carriages, but since they only show how to set the wheels this is irrelevant.
The train cars from https://www.printables.com/model/115759-train-for-wooden-tracks are nice, but I've had a hellish time finding 3mm rods (and cutting them) and spherical magnets. So I remixed the cars' bottom part to get rid of non-3D printed stuff.
All top parts of cars from the original model are compatible (included them here for ease of download).
Now, wheels just clip into position, and cars link together with a small printed-in-place tether.
![]() Wheels clipped in place, no metal rod | ![]() Cars' tethering |
You do not need the original model's “bottom part”, which was used to affix the wheels' axis. Just print the car body, add the wheels and the topping you want, and play.
You may glue the top parts for the cars, but depending on your printer's settings and filament, it may be enough to use four 3 or 4 mm clips of 1.75 mm filament, one in each hole of the car's body and top.

Wheel has been slightly updated to allow for an small plastic axis to ensure the wheel stays put. The original model's wheel is also compatible. If you use those axises, be sure to properly put them into place (maybe with tweezers). Since they look like sweets, it would not do for an axis to fall out and be eaten by a small kid.
![]() Optional wheel axis before insertion | ![]() Wheel axis in place |
Supports are needed to print the carriage's body, but only for the hook and loop on each side.
Printing with 0.2mm layer height, 15% gyroid infill, gives good results. You can go with a 10% infill if your filament makes good bridges.
Use the tracks from https://www.printables.com/model/117903-extended-set-of-wooden-train-track-with-50-unique- or from any compatible toy set.



