HeroMe Gen7v3 Sovol SV04 Gantry Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SV04 Gantry adapter for HeroMe Gen7
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 504
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed to create a gantry adapter for my SV04 for a project to add my E3D Titan and Volcano hotend.
Screw holes were a bit tight, but able to make it work. Only downfall of this model is that Sovol only included two screw holes on the same side for each of the gantrys on the SV04. This means it will have some play off the gantry on the opposite side of the screws. I simply threw some super glue between the gantry and the adapter on the non-screw side and this seemed to lock it in place. Not ideal, but it's what I was working with.
Believe the screws needed for this are M4. Blanking on what length I used. Probably 4-6mm or so.
Including the Fusion file in case someone wants to make it better. I was in a rush so I am sure there are minor fixes to make it work better.
These M4 bolts should work (let me know if they don't). The Sovol Gantry has some space behind it and just need to tighten the adapter down: https://amzn.to/41JeFTY
I wrote up the changes I did to make this work here: https://thefilamentfeed.com/upgrading-our-sovol-sv04-with-e3d-titan-extruder-and-volcano-hotend/
Hope this is clear enough to make it work for you. This setup has been utilized only 30 or so times since the change as I received some newer printers but it’s not failed me yet.