Wall mount for Ubiquiti NanoStation AC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ubiquiti NanoStation AC PtP bridge mount for pan/tilt wall mount.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 223
- Wydruki
- 1
- Wyświetlenia
- 1128
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is an outdoor wall mount I made for a couple of Ubiquiti NanoStation AC PtP/PtMP bridges so I could angle them up/down and side/side. The mount it comes with is a flat wall mount.
PLA
I printed the posts on both mounts at 100% infill and the remainder at 30% infill, but all could be printed at 20%-30% infill. They're plenty strong at 2-%-30% infill because the NanoStation AC is extremely lightweight.
Addl parts: ¼" x 2" bolt, ¼" knob, ¼" washer
The NanoStation mount is in 2 colors in the picture because I ran out of black filament during the print.