LTT Screwdriver Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a very simple LTT screwdriver holder I put together.
- Ocena
- 4,909 / 5
- Polubienia
- 83
- Pobrania
- 300
- Wydruki
- 13
- Wyświetlenia
- 1986
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
"I wanted a place where I could always put my screwdriver and always be ready to grab and use. Not perfect, but relatively happy with it and does the job.
Time Taken on Bambu X1:
- 42 minutes for base
- 30 minutes for other pieces
You will require:
- 1 x Base Bit Side
- 1 x Base Handle Side
- 1 x Middle Connector
- 1 x Screwdriver Handle Holder
- 1 x Screwdriver Shaft Holder
- 2 x Base Cap
15% Infill
0.2 Layer Height for the base
0.16 Layer Height for the other pieces
All friction fit, however I have included a “full” variation if your printer can fit 215mm for the full thing.
No Supports!
Update 06/05/24: I've added an option for the base without it being split in half for another joint. I've not tested this version but it is just the same base design but not split. Just to have an extra option. This has been added to the “Base” folder and called “Base Full Size.stl”