Motorcycle License Plate Frame (California)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thin License Plate Frame that fits California motorcycle license plates.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 385
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
I wanted a custom license plate frame for my motorcycle and other models I found didn't actually fit my new California Motorcycle license plate. I do not know if other plates will fit. It can accommodate a plate that is 180mm long and 102mm high (there is an extra 10mm below the plate because the bottom border was enlarged so custom text or images could be added). The bolt holes are 7.2mm in diameter, 20.8mm on center from the top, 145.4mm apart (left to right) on center, and 67.4mm on center apart from each other top to bottom.
I printed this at .2mm layer height. Infill doesn't matter as it's thin enough to print solid. I use 3 perimeters for the maximum strength around the bolt holes. If you want to add any custom text or images to the frame you have to print it face up with supports turned on as there is a lip on the back of the frame. If left blank I imagine you could print it face down with no supports but, I haven't tried this. I'm not sure if PLA will hold up to sunlight and the wind; PETG or ASA will likely hold up better.
Edit Aug, 2024: Added a .stl file for the blank plate frame by request. Also, my PLA plate frame is still holding up after sitting in the sun at work for most days this summer and about 1000 miles of travel this year.
Included is a version with Mt. Shasta on the frame.