R. Maker - Mark I
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Official MakerBot mascot from the Original Creator (Uploaded to the Thingiverse on September 17th, 2011)
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 535
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
This is my submission to the MakerBot Robot Mascot Challenge!
A few comments:
Although I am no stranger to 3D modeling, this is my very first model intended to be 3D printed. I do not own a 3D printer of any sort and I have never 3D printed anything. That being said, I tried my best to research good design practices for FDM printing and I sure hope I did all-right!
Anyhoo, this little guy is customizable by having different parts printed in different colors. Also, he was designed to be able to be personalized by the producer being able to place his or her own model in the body to add personal flair. The feet articulate as do the head, arms and claws. Everything should snap together. The spool on his back is Mr. Maker's fuel supply! Take some 1.75mm filament and wind it on the spool (you may have to warm it to be more pliant) then thread the end through the top of his head.
Now he's ready to go!
I designed this in about 10 hours with Autodesk Inventor 2012.
(Many thanks to "techknight" for the advice on re-orienting the models in ReplicatorG!)
Also, I would LOVE to know how well this prints. I tried very hard to be mindful of the vertical slopes and tolerances but this being my first design for print, I don't really know for sure. If anybody prints this, I would GREATLY appreciate it if you could explain any issues. THANKS! :)
Instructions
Print 2 of the Arm Pegs, Eyes, Shoulders, Shoulder Pegs and Claws. Snap together!