Adhesive Headphone Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Headphone hanger designed to be stuck to a vertical surface via 3M VHB. Suitable for headset bands sized 43.5mm or less.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Headphone hanger designed to be stuck to a vertical surface via 3M VHB. Suitable for headset bands sized 43.5mm or less.
Designed to hang up a SteelSeries Arctis Pro Wireless, other SteelSeries headsets have the same approx dimensions and will probably fit too.
Uses a 50mm 3M VHB adhesive disk to adhere to a surface e.g. the side of a display case.
Version in the photo was printed at 0.28mm layer height with 40% infill, but that's likely overkill. Wouldn't go lower than 20% though, but I don't know how heavy your headsets are.
The adhesive disk indent is 50mm across, so depending on how good your printer is at bridging, supports may or may not be required. Mileage may vary.