Weed Puller - 1/2" EMT
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, effective, low cost weed puller using 1/2" EMT.
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 1463
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple weed puller using ½" EMT and 3 ½" 16D galvanized nails. To remove weeds, push over weed, twist handle and pull.
If you prefer to use ¾" PVC, use this model: https://www.printables.com/model/461240-weed-puller-34-pvc
Cut length of EMT tubing to a comfortable length (36-46").
Hammer nails into tip with the tubing opening facing up. Make sure to recess nail heads. Secure to one end of tubing with super glue. Use rivet holes to drill tubing using 1/8" drill bit. Secure with rivet (5/8" x 1/8") or metal screw.
Secure handle to the other end of the tubing using super glue. Use rivet holes to drill tubing using 1/8" drill bit. Secure with rivet (5/8" x 1/8") or metal screw.
Depending on your printer calibration, you may need to adjust XY scaling (98%-102%). Use “fit-test” part to determine best fit vs scale. Apply same scaling to other parts.
Print with PLA+ or PETG with at least 4 shells/walls. Print in the orientation provided. No supports required.