Shower Head Holder Replacement 25mm Tube toolfree install
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
shower head holder for 25mm rod requires no tool to install, no need for removing the tube from the wall
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 119
- Wydruki
- 1
- Wyświetlenia
- 575
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The thing that holds my shower head broke apart and I didnt want to remove the tube from the wall like it is necessary for other models. This is made for 25mm shower rods and standard ½ inch tube shower heads
The ‘bumper’ is not necessary, but it helps to fix it, preferable print this in TPU or use something else, rubber like material. But also works fine without, may depend on your metal tube. edit: I use it without any rubber support for a month now without it sliding down or other problems. Funnily its so strong that the tube spins in the wallmount if I twist the showerhead holder. I keep it in the files, if someone needs this.
The other parts can be printed in PLA or PETG, keep in mind that water can make PLA brittle over time
The tolerances are tight and fit on my printer, but you may need to adjust the size on yours get a good fit. I would also dry run the screw a few times before installing to break the thread free.
Depending on your slicer settings you may want to change infill density on the thread for more stability.
Print on the flattened side for stability. I used support on the showerhead hole side and also on the thread, rest doesnt need it, see pictures for placement.