1 / 6
Anycubic Kobra Go Dual Z Mod with Timing Belt
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual Z Mod for the Kobra Go that uses timing belt
- Ocena
- 5 / 5
- Polubienia
- 78
- Pobrania
- 348
- Wydruki
- 5
- Wyświetlenia
- 3767
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 5) (Komentarze: 42)Remiksy (4)Kolekcje (90)Powiązane
This is a remix of DrumsticknDrumstick's Anycubic Kobra neo/go dual Z mod but without the additional stepper motor and uses a timing belt instead. This makes the mod a little less involved (i.e., no additional electronics to fiddle around) and has the advantage of keeping both z-lead screws in sync keeping the gantry leveled.
Follow along DrumsticknDrumstick's step-by-step to do this mod but note the differences below.
Hardware needed:
- 350mm TR8x8 lead screw
- 24" GT2 timing belt
- GT2 Pulley 20 Teeth 8mm bore 6mm
- 608 bearings
- M3 bolts to fix the bearings to the mounts
- M5 bolt and nut for the tensioner bearing/idler
See pics on how each printed parts are installed.
Notes:
- The bearing blocks are fixed to the aluminum extrusion just like in the motor bracket from DrumsticknDrumstick's
- Print parts as oriented and without supports; the bearing blocks have supports built-in; remove after printing