SEGA Gamegear speaker mount for stereo mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Right side speaker mount for the SEGA Gamegear stereo mod
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 854
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This speaker mount reuses two screw posts from the front shell as anchor points. No cutting required, just drop the mount, install a second speaker (either standard or premium - see below for explanations), run the wires along the shell and you are set.
I made this mount after I purchased a replacement sound board (V1.7 with stereo outputs) and premium speakers from SYF:
https://syf.nl/products/game-gear-stereo-sound-board-v1-7
https://syf.nl/products/speaker-for-game-gear?variant=46474471145819
The premium speakers are taller than the standard ones and will not fit with an original dual ASIC mainboard. Those only fit with a VA1 mainboard or the mainboard SYF sells on his site.
Note: when the speaker is installed in the mount, it will be flushed with the mainboard. There shouldn't be any rubbing there but overtime repeated contact could leave some marks on the board (unlikely unless you shake that bad boy non stop). I recommend putting some Kapton tape on the top of the speaker or on the area of the board where the speaker will be in contact just to be safe.
Printed in 0.2mm layer height, PLA, upside down with organic (tree) support, 15% infill.
Feel free to reach out if you have any questions!