1 / 6
75mm magnetic vacuum hose quick connector — zdjęcie 1
1 / 6

75mm magnetic vacuum hose quick connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic quick connect vacuum hoses (same or different sizes).

Ocena
5 / 5
Polubienia
132
Pobrania
306
Wydruki
1
Wyświetlenia
1758
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Magnetic quick connect vacuum hoses (same or different sizes). 

Connection is 75mm internal diameter. Requires 12 10mmx3mm magnets. 12 magnets provides a strong connection that does not accidentally disconnect. 

Recommend alternating the magnets polarity. This allows for a simple twist to disconnect. It also means that any two connectors can connect.

All adapters have:

Magnetic connector end:

  • 75mm internal diameter
  • Positions for 12 magnets, 10x3mm in size (magnet recess is 10.5x4mm).
  • 3mm material around the magnets.
  • 7.5mm flange thickness

Hose end:

  • Outer Diameter:
    Intended for the printed nozzle to go inside your existing hose.
    • Hose sizes: 1"- 4.5", 25mm-100mm
    • Sizes are for the inside of the hose (outside of the printed nozzle)
    • 3mm from small to large -1.5 to +1.5
    • Has a hose stop on the outside
    • 40mm long connector at each end
    • Wall thickness of 2mm
  • Inner Diameter:
    Intended for the printed nozzle to go over your existing hose or nozzle.
    • Hose sizes: 1"- 4.5", 25mm-100mm
    • Sizes are for the outside of the hose (inside of the printed nozzle)
    • 40mm long connector
    • 2mm taper large to small +1 to -1
    • Wall thickness of 2mm


2023-11-27

  • Added internal diameter (ID) measurements for putting the adapter over a hose connector on a tool.
  • Added short connector for ID, prevent it from bottoming out.
  • Added caps, to close off or dock the adapter

Tagi