Constant Torque Spring Mount for KiMe kinetic sculpture
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a way to add constant torque spring (found in retractable measuring tape) to the KiMe kinetic sculpture.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 193
- Wydruki
- 1
- Wyświetlenia
- 1424
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement for the plastic springs in the KiMe kinetic sculpture with constant force springs found in tape measure.
All parts were printed in PLA 0.6mm nozzle and 0.36mm layer height. The Spring holder and Bottom part were printed with 3 walls and 15% infill, the top disk was printed with 2 walls 10% infill.
Use this guide to remove springs from a tape measure: https://www.ifixit.com/Guide/Tape+Measure+Spring+Replacement/130585
These spring can unwind very quickly and cause cuts or other injuries so wear gloves and handling these carefully.
- Place the Spring holder in the Bottom part and check if it spins freely.
- Remove the spring from the tape and place it in the spring holder (Note the orientation of the spring). Slowly let go of the spring and it should unwind into the holder.
- Hook the tip of the spring into the slot.
- Tightly fit the top disk on the spring holder.
Place this assembly in place of the springs and it should work same as before.
Thank You