Voron Trident-R1 rear WobbleX carriers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear MGN9H Z carriers for WobbleX on Voron Trident-R1
- Ocena
- 5 / 5
- Polubienia
- 65
- Pobrania
- 274
- Wydruki
- 4
- Wyświetlenia
- 2699
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Trident-R1 rear WobbleX carriers
CHANGELOG
01.05.2023: Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.
26.04.2023: Initial release.
Printing:
Default voron settings, correct orientation, no supports needed!
Bom:
1x WobbleX WS8
Stock Voron Trident screws etc.
Description:
Since it's been a couple issues with the stock rear WobbleX Z carrier, which i have fixed for my MGN12H version i figured i could apply the same fixes to the MGN9H so that it's out there for those who need it. So here you go, enjoy!
It's also been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers & TR8 adapters.
10.5mm(old) vs 13mm(new)
- - -
In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!