Ryobi P737D Inflator Trigger Guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Trigger guard to help prevent the inflator being switched on by accident.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 114
- Wydruki
- 1
- Wyświetlenia
- 675
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is a trigger guard for the Ryobi P737D 18V inflator. Found it'd get triggered sometimes when I'd toss it in my trunk when going biking.
Printed in two pieces to increase the strength of the parts. Can attach with a single screw, but be sure not to use one that's too long. Been using it for a while and I think there's no need to glue it (either the parts together or to the inflator) unless you are rough on your tools. Just align the parts as shown in the picture and drill a hole at the same angle as the one in the guard using it as a drill guide (too deep and you might hit something inside the case, so just go through the thickness of the inflator's plastic body shell).
I think PLA is fine unless you want more temperature resistance (if stored in the hot trunk of a car, for example). 0.2 mm layer height is fine and an adhesion brim will help a lot when printing the bracket model.
Step versions are included to facilitate customization.