1 / 1
Bracelet Jewelry Display T-Bar Two Part print
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed to allow more central position of T-Bar for balance of heavier watches.
- Ocena
- 4,333 / 5
- Polubienia
- 72
- Pobrania
- 283
- Wydruki
- 2
- Wyświetlenia
- 1168
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 3)Remiksy (0)Kolekcje (94)Powiązane
Remix of the original. Now a two part print with the T-Bar more in the middle and with a slightly deeper base. Should balance better for heavier jewelry. You can either pressure fit the T-Bar into the base or use some adhesive - there's a gap between the base and the bottom of the T-Bar that inserts so lots of room for some hot glue or something similar.
I printed the base face down with supports for the T-Bar socket. This gives a perfect finish when assembled.