1 / 4
Refill-Spool (56mm and 32mm) — zdjęcie 1
1 / 4

Refill-Spool (56mm and 32mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I looked for adequate spool, so I grabbed some ideas and combined with my own design and slice.

Ocena
0 / 5
Polubienia
9
Pobrania
59
Wydruki
0
Wyświetlenia
245
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I looked for adequate spool, so I grabbed some ideas and combined with my own design and slice. Outer plates are about 3.65mm, 0.2mm first LH, others 0.25mm.

I took veehexx's design of the threads, modified them with some chamfering for better fitting, designed new plates from scratch, leaning on “Nachdenksport's” design and put everything together. I like the flexibility of the threads, so you can put or adjust a tension i.a.w. your like.

I added two sets of filament holes in the outer plates, those are pretty generously sized AND they are in a 30 dgrees angle so your filament doesn't break so quickly. Two more sets of angled holes (but smaller) are in the near of the core for fixing the end strand of the filament for better fixation or upwinding in case you wind filament (leftovers) up.

The slicing preparation was quite tricky, learned from others, learnt from my experience. Thus the attached .3mf-files should help anybody elso who likes the honeycomb design, open towards outside.

Printed on my Voron 2.4 (350), printed in HIPS, slow speed, 100°C bed, 250°C nozzle. Outcome is pretty amazing to me. The threads fit 100%, HIPS has a smooth surface. 

Will also try it on my MK3S+ 

Is also a nice project for getting rid of leftovers of filament. Enjoy!

Tagi