Gridfinity bin for Sony NP-FW50 batteries
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 4x of the Sony NP-FW50 camera batteries used in the Sony Alpha camera range
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 162
- Wydruki
- 1
- Wyświetlenia
- 1191
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Gridfinity compatible:
- 1x3 grid size (and 50mm tall - non stackable)
- Includes sockets for the standard gridfinity 6x2mm magnets
(I found magnets unnecessary due to the weight of the batteries since I only take out one at a time. I left them in the design since they print without supports, unlike the original gridfinity magnet+M3 combo design)
Holds 4 of the Sony NP-FW50 batteries used in Sony Alpha cameras:
- Early Sony Alpha A7 series (A7, A7R and A7S generations 1 and 2)
- Sony Alpha 6000 series: A6000, A6100, A6300, A6400, A6500 (but not the A6600)
- Sony Alpha A5000 series
- Sony NEX series (the predecessor for the Alpha
Batteries are slanted forwards for easy removal/return when placed on a shelf or in a deep drawer. I tested with both original Sony batteries and aftermarket ones by Ravpower (from amazon) - the originals have a nice and loose fit and are very easy to remove with one hand. The aftermarket ones fit a bit tighter)
This was printed with the following configuration:
- eSun PLA+ filament on an Ender 3 S1
- Print temps: 210 C hot-end and 60 C bed
- 0.3mm line height, 0.4mm line width
- 2x walls, 3x bottom/top layers (0.8mm and 0.9 mm respectively)
- 60mm/s print speed
- 10% cubic infill
- no support, no bed adhesion