Purge bucket with editable size and tilt angle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model and Fusion 360 source file for a purge bucket. You can edit the bucket's size and tilt angle.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 148
- Wydruki
- 2
- Wyświetlenia
- 809
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the purge bucket from the "Nozzle Scrubber with a Little Bucket for Voron 2.4" model by FunFunBoy.
I liked the original model but found it a bit too small. So I created a larger one and also added a tilt. This allows you to let gravity pull some of the filament down to the bottom/back of bucket.
The attached STEP file adds 10mm of depth, 30mm of length, and 20mm of width to the original bucket. The tilt angle is 10 degrees. Those values work well for my setup.
The attached Fusion 360 source file allows you to customize all of those values to suit your own needs.
Open the model parameters to customize the values:
Check out the remixed model for the accompanying brush mount.
Hardware I've used (affiliate links):
- 6x3 magnets: https://amzn.to/3M7iihd
If you like what I'm doing…
…consider buying me a ☕ on Ko-Fi.