1 / 7
Mitsubishi Outlander REMCU Signal Cable Gland — zdjęcie 1
1 / 7

Mitsubishi Outlander REMCU Signal Cable Gland

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Many used Outlander Inverters/Motors don't come w/ cable pigtails, with this gland you can replace it with generic conn.

Ocena
0 / 5
Polubienia
10
Pobrania
33
Wydruki
1
Wyświetlenia
313
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

This gland can be used for the Signal cables

 

Versions

  • M16: For small diameter cables or Bulgin PX connector (or similar).
  • M20: For larger diameter cables.
  • Waipu SP21: If you want to replace the original connector with a 7- or 9-pin Waipu SP21 connector.

 

Recommended Material & Print Settings

  • 0.1mm Layer height for good thread resolution
  • The M16x1.5/M20x1.5 thread can be tight if there is too much extrusion
  • The test prints were made with PLA, if you want to use it in a car better use ABS, PETG, …
  • The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.

 

Additional Hardware

  • 26x3mm O-Ring
  • M16/M20 cable gland or Bulgin PX connector

For Waipu SP21 only:

  • 2x M3 heat set inserts
  • 2x M3x8 screws

 

Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.

Tagi