Ender 3 Heated Enclosure Relocate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to set up my Ender for success with Klipper and printing with an enclosure.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 333
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't find anything that fit what I wanted for my new heated enclosure that would safely and effectively organize and house my electronics. I run Klipper and have a Meanwell PSU and wanted everything to be kept in the same part.
This will use all of your cables, and your current power switch. Using some cable extensions like;
https://smile.amazon.com/dp/B0784PQQFX?psc=1&ref=ppx_yo2ov_dt_b_product_details
will save you some headache from re crimping the connectors.
Four 12mm x 4mm magnets go into the bottom of the case, and some super glue will keep them in there.
https://www.magnetsource.com/products/07046
You will need some wire and XHF connectors to extend your heater wire for the hotend and bed.
https://smile.amazon.com/dp/B01ABOPMEI?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://smile.amazon.com/dp/B01ABOPMEI?psc=1&ref=ppx_yo2ov_dt_b_product_details
Four M4-3mm Screws and eight plastic washers with a 4mm ID hold the PSU tight to the upper lid of the enclosure.