Original Bambu Lab Armor Modplate for P1P

Very important for a successful print so that the parts do not detach from the print bed, it is my successful settings.

Filament Settings for generic PLA (Jayo/Sunlu):

First Layer 225° then 220°

Textured PEI sheet first layer 70° then 65°

Print settings:

First layer 0,25 then 0,20

Layer wide 0,50

Infill 15% Gyroid (not grid, this is the main problem because the nozzle scratches over the grid infill and detaches the objects from the print bed)

Brim 15 mm

Fist layer speed 50% (noise on P1P)

In the upper area at the infill print (approx. from 70%) speed 50% (noise)

Printed on P1P without Support

In my opinion the screws by Bambu are too short for the modplate, i recommend using a little longer screws.

Thanks for downloading in advance and please don't forget to like this modell!