Yeti 30oz Rope Handle / Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rope handle for Yeti 30oz tublers and generics!
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 95
- Wydruki
- 2
- Wyświetlenia
- 669
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is a remix of UpTime's FlexDually rope handle for 30oz tumblers and generic tumblers.
While I liked the original design, it required inserting/snapping connectors into the handle and the rings. This also required using glue to secure it. I found the connections pretty loose and the thin section where the bracket inserts into the hangle snapped off on assembly.
In this design, the rings screw into the handle. This not only creates a more rigid holder that does not require glue, but also has the added benefit of being able to somewhat adjust the upper ring if you have text or a design you don't want covered.
The original design required support on all parts to print. In this design, only support is needed on the build plate for the handle to support the bridge on the lower thread hole. Screwing the rings into the handle is a bit tight but doable. I suggest printing the rings with at least 3 walls and 25% infill so that the threaded column does not snap off as your are twisting into the handle.
The handle should work with generic tumblers as well. The photo shows the holder being used with a Polar Camel tumbler.