Promaster Sliding Door Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Winnebago Solis RV / Ram Promaster 3500 sliding door handle, larger than the original making it much easier to open.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 177
- Wydruki
- 1
- Wyświetlenia
- 1064
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
I have a Winnebago Solis RV, which is basically just a Ram Promaster 3500. Everybody hates how small the sliding door handle is, so I designed my own. Larger, easier to use.
Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.20
Infill:
55
Notes:
For the best strength, you should print in the orientation you get when you download it, don't rotate at all. I also used 55% infill on it, triangles, because the design will never be twisted in any other direction so that was a good balance of high strength, low print time.
Then you'll need supports for the whole thing. Normally I recommend tree supports, but it wasn't needed for this model.
At the moment, I just installed on my van and it works great, but I haven't tested anything long term yet. Keep your old handle around just in case.