Bus pass sticker keychain holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds those University bus pass stickers that they put on your student ID
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Let's you put your university bus pass sticker (approximately 26mm high and 45mm wide) on a tiny tag that you can put in your keychain instead of your wallet for easy tap. Requires some careful peeling.
V1: Initial Version
V2: Added two notches to prevent any possibility of the tag falling out, Increased the tolerances a touch more, new keychain loop design, base uses less plastic.
Print settings:
Layer Height 0.2
Infil: ≤15%
Slices STLs as shown in one of the screenshots.
Instructions:
Carefully peel off the sticker from the card, be sure to start the middle of a wide side of the sticker and with your nail slide it around the perimeter of the sticker until the sides are completely off the surface of the card. Do not kink the sticker because there are delicate things on the bottom of the sticker.
(Optional) With the sticker off the card, you can put it on transparent plastic sheet (ziploc bag or tape is fine) thats the same shape as the sticker so if you decide in the future to put it back on your ID for some reason.
Place the sticker between the two halves of the bottom and top parts of the tag, align it so the edges are sticking out.
Press both pieces together and they should snap fit.