1 / 5
Juxtaposed Y-splitter for BambuLab P1P / X1C — zdjęcie 1
1 / 5

Juxtaposed Y-splitter for BambuLab P1P / X1C

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you too didn't find the Y-splitter which fits your need, well try this one. You should not regret it.

Ocena
4,938 / 5
Polubienia
110
Pobrania
807
Wydruki
14
Wyświetlenia
3696
Oceny
16

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Hey everyone,

 

I've been looking for the Y-splitter which:

-Looks good

-Works well

-Can be attached to the frame

-Get ride of the stock coupler

-Is invisible from the front of the machine

 

Well… I had to roll my sleeves up !

 

Here is my version, this one is Juxtaposed so the filament has the exact same curve in it and imit the PTFE one when connected to the buffer.

It works just perfectly.

In order to use it, you will just need 2x 4mm G1/8" push-in adapters 3175 04 10:

https://www.amazon.ca/-/fr/3175-04-10-poussoir-Connecteur/dp/B009PTE5TY

Holes are pre-threaded, you just have to screw the 2 fittings and it's ready to go.

To attache it to the machine, just use a M3x6 screw as shown in the pictures.

 

Tested around 20 times with the AMS, not even ONE jam.

 

 

Please share your prints !

Tagi