Unifi Bullet G3/G4/G5 mount

I received an old Unifi G3 bullet without any of the mounting for it, so i borrowed a friends mount and made my own. it works pretty good. I recommend printing this in ABS, ASA, or PETG if your using it outside. but I'm sure depending on if the spot gets direct sunlight or your climates a little cooler PLA should work great.

8/24/2025. I have reworked the design a bit to fit the camera better, slicers and printers have gotten good since i originally made this so I have made part 1 fit better to the camera. if it doesn't thread good check if your printers over extruding and then see how the overhang setting are. I have also found taking a thread gauge for checking thread pitch works really well for cleaning up the threads if say you get some blobs in there or its a little tight. they're a 1.5mm pitch. I also changed part 3 to have a thicker lip at the bottom flange to help hold the camera a little tighter along with part 4 being shorter so the threads don't bottom out before its tight. I will be leaving the old parts here just in case but ill label them and put them in a separate folder.