sovol SV06 bearing holder for Y-axis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Y-axis bearing holders for SV06 that don't cause binding when tightening the screws.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 128
- Wydruki
- 1
- Wyświetlenia
- 971
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I made these bearing bushings to replace the stock ABS parts that hold the bearings to the bed support. In my printer the og parts were undersized and caused binding when tightened down the screws.
This will fit standard lmu8 linear bearings. One user confirmed they also fit the igus drylin bearings. The id of the printed part is 14.95 for a press fit.
The bearings are press fit in the bushings. I printed this in PETG to allow for some flex. I printed this on the side to maximize the accuracy of the bushing sizing.
This upgrade significantly improved my input shaping results.
Y-axis before:
Double peak at 32 Hz and large peak at around 12 Hz.
Y-axis after:
Single peak at 32 Hz and small peak at 12 Hz. Much higher recommended acceleration!