Holder for SUNLU S2 dryer for FLSUN V400
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holder was designed especially for mounting SUNLU FilaDryer S2 on the top of FLSUN V400.
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 426
- Wydruki
- 1
- Wyświetlenia
- 2520
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This holder was designed especially for mounting SUNLU FilaDryer S2 on the top of FLSUN V400.
This holder is attached to the dryer through standard mounting holes (replace the standard self-tapping screws with longer ones. at the same time, make sure that they are not too long so as not to damage the dryer)
The holder attaches to the top of the printer with two screws into standard holes on the top of the side rack, plus one self-tapping screw near the filament inlet (this is desirable but not required. in case if you will, you must drill a hole of the appropriate diameter. you will find place for hole using the holder as pattern)
I used as filament guide the Creality copricorn premium PTFE bowden tubing.
Material PLA
Print time about 1h46min
You can use .3mf file as project for Prusasliser (for FLSUN V400, bed mesh is adding in the start g-code)