Reinforced 20mm Bench Dogs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
20mm (Festool MFT bench hole sized) Bench Dogs made with PLA but reinforced with nut and bolt.
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 146
- Wydruki
- 1
- Wyświetlenia
- 1060
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
20mm (Festool MFT sized) Bench Dogs made with PLA but reinforced with a 5/16th 2.5" bolt and nut. Alternatively, a 60mm M8 bolt can be used to reinforce. The leg and head are printed separately to avoid the need for support.
The leg diameter is 20mm and fits perfectly when printed with a 0.8mm nozzle and 0.32mm layer height. The bolt fit is tight in the leg, but can be pushed in by hand, or lightly tapped on a handy workbench (not your best table), or with a hammer.
The bolt head and nut recess into hexagonal holes so that top and bottom can be screwed together by hand, with no requirement for tools.
If there is demand, I'll do some for ¾" dog holes too.
I've also made a jig for drilling 96mm on-center 20mm holes which takes advantage of a 20mm drill bushing sold by Lee Valley.