Phaetus Taichi top mount EBB CAN 42 Sapphire plus / SP5

Direct drive Phaetus Taichi and EBB CAN 42 mount for Sapphire plus SP-5.

I used Sailfin extruders, since they have smallest footprint. Files can be found here. You will need two of them, normal and mirrored.

Two pieces of bowden are required from Sailfin to Taichi.

All screws, except Shroud mount and fan require brass inserts M3.

Two long screws are required on back mount for securing CAN mounts and belts. They are fixed with square nuts, as well as two in the front

Two 5020 blowers for part cooling. Wires goes under front cover.

EBB CAN 42 provides only one stepper, wires for second one needs to be installed.

CAN is connected with UTP CAT5e cable, two pairs of strands for power and one for signal, one is reserve.

I printed everything with FormfuturaCarbonFil™

.zip contains load unload and switching extruders config for klipper.

.step is included

Lost approx 25mm on Y. 

                                                                       **EDIT**

V2

Improved part cooling. On picture of 2 benchies it can be seen old (left) and new (right) result. Same file, 38min benchy.

Need to print new Main mount front V2, Shroud L V2 (mirror it in slicer so you have two mirrored parts) and BL touch is moved to the front (offset 0, 40). Hot press M3 brass inserts in shroud. 

Front cable cover is not needed any more.

New cable mount, it attaches to both Sailfins

New print size is 300x285mm