BMP280 BME280 V Slot Sensor Housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little box with holes in for your sensor. Measure temperature, pressure & humidity
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 1298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
…Please be sure to hit like & post a make, I'd love to see your prints!
Install your BMP/BME280 sensor on any V-slot.
Or use base with no mount for glue on application.
Measure temperature, pressure & humidity on your Rpi.
You'll need:
1x BMP/BME280 sensor
2x M3 SHORT heat inserts
1x M3 4mm Cap head bolt
1x M3 10mm Cap head bolt
1x 4 pin DuPont connector
1x length of 4 core wire the desired length
1x the knowledge to set up the sensor in your chosen system!
Search Octoprint Enclosure or read the Klipper docs
link to sensor used:
Printing:
Make sure your printer is setup well, this thing is pretty small!
PLA+ 0.20-0.30mm layer height
Print base laying flat
Print cover standing on its flat end that has no vents with supports inside
….you can print it on its lid but the overhang tends to look a bit messy