1 / 1
ELOPS CL500 - bike lamp mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to mount the lamp onto a rack and the original silicone mounts proved to be too large.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 53
- Wydruki
- 1
- Wyświetlenia
- 609
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
I wanted to mount my bike lamps to the thin bar of my bike rack, which I wasn't able to do with the original mounts.
I uploaded two versions:
- rounded back with holes for zip-ties
- flat back without the zip-tie holes (for easier modification)
I printed it standing upright on the narrow edge (with brim) without any supports.
If you don't use supports there will be one strand of material that will not print properly, but other than that it is fine.
I printed them out of ASA for better weather resistance, though PLA would be fine proably.